Burndy Wiley ACC-F90-1 Installation Instructions

Acme cable clip

Wire Management Solution

ACME CABLE CLIP

INSTALLATION INSTRUCTIONS

Burndy LLC recommends that the sufficient details of the installation be

submitted to the AHJ for approval before any work is started.

ACC-F90-1

LISTED

E473109

Products are tested to UL 1565 & CSA C22.2 No. 18.5-13,

US/ Canadian standards for safety Positioning Device.

Document Number 50086749 Rev A

Page 1 of 4

Table of Contents

Need help?

Do you have a question about the Wiley ACC-F90-1 and is the answer not in the manual?

Page 1 Wire Management Solution ACME CABLE CLIP INSTALLATION INSTRUCTIONS Burndy LLC recommends that the sufficient details of the installation be submitted to the AHJ for approval before any work is started. ACC-F90-1 LISTED E473109 Products are tested to UL 1565 & CSA C22.2 No. 18.5-13, US/ Canadian standards for safety Positioning Device.
Page 2 Compatible on modules with a flange thickness [1-2 USE-2 wires or 1-2 PV wire] range 1.3mm to 2.5mm Wire Diameter range 4.1mm to 7.0mm (per each wire) Document Number 50086749 Rev A © 2017 BURNDY LLC. Page 2 of 4...
Page 3 ACC-F90-1 SPECIAL FEATURES Rolled edges to prevent damage to cable insulation Straight on or 90 degree module orientation Document Number 50086749 Rev A © 2017 BURNDY LLC. Page 3 of 4...
Page 4 ACC-F90-1 OVERVIEW Can be used to run string wires across modules Or to secure module wires Note: into module frame Application: Module frame flange mounting Document Number 50086749 Rev A © 2017 BURNDY LLC. Page 4 of 4...