Setting And Adjusting The Projector; (Settings & Adjustments); Setting The Security (Network - Security) - Sharp XG-P560W Setup Manual

Controlling the Projector via LAN
Setting and Adjusting the
Projector
(Settings & Adjustments)
Example: "Picture" screen display for COMPUTER1
On these screens, you can make projector
settings or adjustments. You can set or adjust
the following items :
• • • • • Picture Mode
• • • • • CLR Temp
• • • • • Progressive
• • • • • C.M.S. Adjustment
• • • • • DNR
• • • • • Signal Type
• • • • • Dynamic Range
• • • • • Color Space
• • • • • Auto Sync
• • • • • Auto Sync Disp
• • • • • Audio Out
• • • • • Internal Speaker
• • • • • Resize
• • • • • OSD Display
• • • • • Video System
(VIDEO/S-VIDEO)
• • • • • Background
• • • • • Startup Image
• • • • • Eco Mode
Note
• If you click the "Refresh" button before the
screen is displayed completely, an error
message ("Server Busy Error") will be dis-
played. Wait for a moment and then oper-
ate again.
• You cannot operate this page while the pro-
jector is warming up.
• While the projector is in standby mode, you
can only control "Power ON".
• For details about each item, refer to the
projector's operation manual.
• For details about the items that will be
initialized in "All Reset", refer to the
projector's operation manual. (The network
setting items will not be initialized.)
-28
• • • • • Auto Search
• • • • • Auto Power Off
• • • • • Password
• • • • • Lamp Mode
• • • • • Lens Type
• • • • • Projection Mode
• • • • • Keylock Level
• • • • • Set Inputs
• • • • • Fan Mode
• • • • • Auto Restart
• • • • • RS-232C Speed
• • • • • Monitor Out (Standby)
• • • • • Video Wall
(See page 44.)
• • • • • Stack Setting
(See page 41.)
• • • • • All Reset
• • • • • OSD Language
Setting the Security
(Network – Security)
On this screen, you can make settings relat-
ing to security.
Items
User Name Setting of user name for
security protection.
Password Setting of password for
security protection.
Accept IP It is possible to set up to three
Address IP addresses allowing connec-
tion to the projector.
All IP No limits are set to IP addresses
Addresses connecting to the projector.
From only
For security improvement, only an
specific IP IP address set by "Address 1-3"
addresses can be connected to the projector.
After clicking the Apply
"
ues appear. Confirm that the values are set
properly, and then click the
Note
• After setting items, wait for 10 seconds and
then re-access.
• User Name and Password can be up to 8
characters.
• You can input the characters below :
a-z, A-Z, 0-9, -, _
• To cancel User Name and Password, enter
nothing and then press "Apply" button.
Description
button, the set val-
"
Confirm button.
" "