Inspection - Weir SPM Flow Line Installation Manual

THIRD
Install the SPM
be threaded through the Ribs already installed on the flow line.
See pages 23-25 of this guide for reference.
TIP - It is recommended to start at one end and work
toward the other end.
TIP - Installers should remember to twist SPM
prior to installing the SPM
This helps ensure a tight installation
FOURTH
Install the SPM
guide for reference.

INSPECTION

In order to ensure the continued safe operation of the SPM
Line Safety Restraint System, Weir Oil & Gas requires annual
SPM FSR inspection. Inspection of SPM
®
must be performed by a Weir Oil & Gas technicians. Contact
your Weir Oil & Gas sales representative at 1-800-342-7458 to
schedule the annual inspection.
The primary mode of inspection is a visual inspection according
to SPM Flow Line Safety Restraint Annual Inspection Procedure.
®
Proof Load Testing is also offered by Weir Oil & Gas. This testing
requires multiple samples to be destroyed by pull-test. Though not
mandatory, this testing offers an additional level of reassurance.
*Identification tags must be punched or marked with the date the
inspection was performed.
Reference Documents for Annual SPM
Weir Oil & Gas Engineering Bulletin 1024
This bulletin briefly explains the annual SPM
details which documentation is required.
FSR main line Spines next. These Spines should
®
FSR anchor line Spines. See pages 31-33 of this
®
FSR Spine main line through.
®
®
FSR Inspection:
®
39
FSR Ribs
®
FSR components
FSR procedure and
®
Flow
®