Turning The Projector On/Off; Turning The Projector On - Sharp XG-MB67X Operation Manual

Turning the Projector On/Off

Turning the Projector on

Note that the connections to external equip-
ment and power outlet should be done be-
fore performing the operations written be-
low. (See pages
Remove the lens cap and press
S STANDBY/ON on the projector or
fON on the remote control.
• When System Lock is set, the keycode input box
appears. To cancel the keycode setting, input the
keycode that you have already set. See page
for details.
Note
• About the Lamp Indicator
The lamp indicator illuminates to indicate the
status of the lamp.
Green: The lamp is on.
Blinking in green:The lamp is warming up
Red:The lamp is shut down abnormally
or the lamp should be replaced.
• When switching on the projector, a slight flick-
ering of the image may be experienced within
the first minute after the lamp has been illumi-
nated. This is normal operation as the lamp's
control circuitry is stabilising the lamp output
characteristics. It should not be regarded as
faulty operation.
• If the projector is put into standby mode and
immediately turned on again, the lamp may
take some time to start projection.
28
23 to 27.)
or shutting down.
Info
• English is the factory default language. If you
want to change the on-screen display to an-
other language, change the language accord-
ing to the procedure on page 45.
47
Lamp indicator
STANDBY/ON button
ON button