Connecting The Power Cord; Connecting The Projector To A Computer - Sharp XG-C55X Operation Manual

Connecting the Power
Cord
Plug in the supplied power cord into
the AC socket on the rear of the pro-
jector.

Connecting the Projector to a Computer

Connecting to a Computer
Using the RGB Cable
1
Connect the projector to the
computer using the supplied
RGB cable.
• Secure the connectors by tightening
the thumbscrews.
2
To input audio signal, connect
the projector to the computer
using the computer audio cable
(commercially available or avail-
able as Sharp service part
QCNWGA013WJPZ).
Note
• See page
93 "Computer Compatibility
Chart" for a list of computer signals com-
patible with the projector. Use with com-
puter signals other than those listed may
cause some of the functions not to work.
• When connecting the projector to a com-
puter in this way, select "RGB" for "Signal
Type" in the "Picture" menu. See page 46.
• A Macintosh adaptor may be required for
use with some Macintosh computers. Con-
tact your nearest Sharp Authorized
Projector Dealer or Service Center.
• Depending on the computer you are us-
ing, an image may not be projected unless
the signal output setting of the computer is
switched to the external output. Refer to
the computer operation manual for switch-
ing the computer signal output settings.
Supplied
accessory
Supplied
accessory
Notebook computer
To RGB output terminal
To audio output terminal
2
Computer audio cable (commercially
available or available as Sharp service
part QCNWGA013WJPZ)
Power code
RGB cable
1
RGB cable
-17