Husqvarna K 535i Operator's Manual page 16

3. Press on the lower part of the battery until you hear
a click sound. If the battery does not move into the
battery holder easily, it is not attached correctly into
the battery holder.
4. Press and hold the start/stop button until the green
LED light comes on.
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the blade speed and gives the
longest operation time from the battery.
Note: The SavE function does not decrease the cutting
power of the product.
1. Press the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Press the SavE button again to disconnect the
function. The green LED goes out.
16
To stop the product
1. Press and hold the start/stop button on the keypad
until the green LED light goes out.
2. Press the battery release buttons and remove the
battery from the battery holder.
WARNING: Remove the battery when you
do not use or when you do not have full
vision of the product. This is to prevent
accidental start.
Basic working techniques
WARNING: Do not move the power cutter to
the side. This can prevent the free
movement of the blade and cause the blade
to break, which can cause an injury.
WARNING: Do not use the side of the
blade. The blade can become damaged and
broken, which can cause an injury. Use only
the cutting edge.
WARNING: Do not use a diamond blade to
cut plastic material. The heat that occurs can
melt the plastic. Melted plastic can attach to
the cutting blade and cause a kickback.
• The product is made for high speed diamond blades
approved for handheld power cutters.
• The product is made to cut in to tiles, light concrete
and stone. Use only for this type of operation.
• Make sure that the cutting blade does not show
signs of damage and that it is attached correctly, see
745 - 008 - 12.11.2018