1. Manuals
  2. Brands
  3. Rivers Edge Manuals
  4. Ladders
  5. RE741 Perimeter
  6. Operator's manual

Rivers Edge RE741 Perimeter Operator's Manual

Ladder pod
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Operator's Manual
RE741 Perimeter™
Ladder Pod
GAS/OIL
RATIO
50:1
PRODUCT MEETS
INDUSTRY STANDARDS
RECOGNIZED BY
PARTICIPATING MEMBER
P/N: 17781
REV3: 03/29/16
© 2016 RETI
Get parts online at
All Rights Reserved
www.HuntRiversEdge.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RE741 Perimeter and is the answer not in the manual?

Questions and answers

Related Manuals for Rivers Edge RE741 Perimeter

Summary of Contents for Rivers Edge RE741 Perimeter

  • Page 1 Operator's Manual RE741 Perimeter™ Ladder Pod GAS/OIL RATIO 50:1 PRODUCT MEETS INDUSTRY STANDARDS RECOGNIZED BY PARTICIPATING MEMBER P/N: 17781 REV3: 03/29/16 © 2016 RETI Get parts online at All Rights Reserved www.HuntRiversEdge.com...

  • Page 2: Table Of Contents

    INTRODUCTION Rivers Edge® Treestands are engineered with you, the hunter, in mind. We appreciate your purchase of one of our world class treestands. Follow these few simple instructions and your stand will provide you many years of trouble-free pleasure. Instructions should be kept in a safe place and reviewed at least annually.

  • Page 3: Warnings

    Operators Manual RE741 Perimeter™ Ladder Pod MODEL RE741 WARNING MAXIMUM USE HEIGHT - 15' 9" TO SHOOTING RAIL A signal device such as a mobile phone, radio, whistle, signal flare or personal locator device (PLD) must be on MAXIMUM OCCUPANCY - ONE (1) your person and readily available at all times.

  • Page 4: Inspection And Maintenance Schedule

    Operator's Manual RE741 Perimeter™ Ladder Pod INSPECTION AND MAINTENANCE SCHEDULE WARNING BEFORE EACH USE PERFORM THE FOLLOWING: Do Not use this product until you have watched the included treestand safety DVD, understand it, and • Inspect all webbing, rope, cord, and strap assemblies for practiced the techniques for safe hunting discussed in wear or damage.

  • Page 5: Assembly And Use Instructions

    Operators Manual RE741 Perimeter™ Ladder Pod ASSEMBLY AND USE INSTRUCTIONS 1/4-20 x 2 1/2 BOLT SELECTING A GOOD LOCATION Assemble this product only in areas that meet the following STEEL WASHER criteria! No overhead power lines near area; open, flat, level, dry ground of sufficient size to allow for assembly, up righting and climbing.
  • Page 6 Operator's Manual RE741 Perimeter™ Ladder Pod 5. Attach swivel (48662) to top of seat post (TP11) using (4) provided 1/4-20 x 3/4” bolts and locknuts. SEE FIGURE 5 NOTE: Make sure head of bolts are on swivel side and nut on bottom of seat post plate to prevent any obstruction when swivel is pivoted during use.
  • Page 7 Operators Manual RE741 Perimeter™ Ladder Pod 8. For assembly of the armrests and shooting rail, you must first remove the “front” (2) bolts/nuts from factory FACTORY INSTALLED assembled seat frame and the “bottom” (4) bolts/nuts from factory assembled backrest frame. Discard this hardware.
  • Page 8 Operator's Manual RE741 Perimeter™ Ladder Pod 13. Attach the ladder foot pads (TP113) to the bottom (short) ladder (TP159) using (2) provided 1/4-20 x 1-1/2” bolts and locknuts. This step now makes this the bottom ladder section. SEE FIGURE 9 NOTE: Channel on foot pads should touch on three sides of the ladder legs.
  • Page 9 Operators Manual RE741 Perimeter™ Ladder Pod 16. Assemble all leg sections together and attach them to the assembled platform in the following order: ASSEMBLED a. Insert top legs (TP145) into the leg pockets attached to PLATFORM the platform. b. Insert middle legs (TP145) into the top leg pockets.
  • Page 10 Operator's Manual RE741 Perimeter™ Ladder Pod 19. Assemble Cross Braces as follows: a. Locate the (2) 12” male cross braces (TP149) and (2) 60” female cross braces (TP131). Insert the male cross braces into the female cross braces. Use (2) provided 1/4-20 x 1-1/4”...
  • Page 11 Operators Manual RE741 Perimeter™ Ladder Pod 20. Install Cross Braces as follows: 21. Once all cross braces are attached to pod, you must now tighten all nut & bolt assemblies. Be sure not to over a. The two cross braces that run diagonally from the top tighten or crush tubing when tightening! Double and ladder section to the top/middle leg joint are the shortest.
  • Page 12 Operator's Manual RE741 Perimeter™ Ladder Pod DETAIL VIEW CROSS 5/16-18 X 3/4 BRACE C BOLT CROSS 5/16-18x3/4 BRACE E BOLT & LOCKNUT CROSS 5/16-18 X 1-1/4 BRACE A BOLT 5/16-18 x 3/4 BOLT & LOCKNUT FIGURE 12 Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5...
  • Page 13 Operators Manual RE741 Perimeter™ Ladder Pod 5/16-18x3/4 BOLT & LOCKNUT DETAIL VIEW CROSS 5/16-18 X 3/4 BRACE C BOLT 5/16-18x3/4 BOLT & LOCKNUT CROSS BRACE E CROSS 5/16-18 X 1-1/4 BRACE A BOLT FIGURE 13 Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5...

  • Page 14: Pod Curtain Assembly Instructions

    Operator's Manual RE741 Perimeter™ Ladder Pod POD CURTAIN ASSEMBLY INSTRUCTIONS 1/4-20 x 1 1/4 SPANNER TUBE BOLT 23. Assembly Pod Curtain as follows: CURTAIN a. Attach the (4) uprights (TP162) to the platform using (4) RAIL provided 1/4-20 x 2” bolts, locknuts and washers.

  • Page 15: Uprighting And Use Instructions

    Operators Manual RE741 Perimeter™ Ladder Pod UPRIGHTING AND USE INSTRUCTIONS WARNING 1. With assembled product lying on ground flat between one leg and ladder section, position one person at feet end Double check assembly steps to be certain you have correctly assembled this product.

  • Page 16: Ladder Pod Illustrated Parts Breakdown

    Operator's Manual RE741 Perimeter™ Ladder Pod ILLUSTRATED PARTS BREAKDOWN 9, 11 DETAIL A DETAIL A DETAIL B DETAIL B Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5...
  • Page 17 Operators Manual RE741 Perimeter™ Ladder Pod ILLUSTRATED PARTS BREAKDOWN Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5...
  • Page 18 Operator's Manual RE741 Perimeter™ Ladder Pod ILLUSTRATED PARTS BREAKDOWN ITEM # PART # DESCRIPTION ITEM # PART # DESCRIPTION 1401B BOLT 5/16-18 X 1-1/4 HHCS GR5 48270B BOLT, (1/4-20 x 2 1/2 HHCS GR5 BLK ZN) 8909B BOLT 1/4-20 X 1-1/4 HHCS GR5 48874 SLEEVE, (BLACK FOAM 66")

  • Page 19: Bolt Identification Chart

    Operators Manual RE741 Perimeter™ Ladder Pod BOLT IDENTIFICATION CHART Not all bolt sizes shown are included with all treestands. Bolts shown are for size reference only. Extra hardware may be included in the parts bag. 1/4-20 x 3/4” Grade 5 Hex Head Bolt 1/4-20 x 1-1/4”...
  • Page 20 Rivers Edge® Treestands, Inc. 1160 Eighth Avenue, PO Box 755 Cumberland, WI 54829 800-450-EDGE (3343) | Fax 715-822-2124 Email: info@huntriversedge.com *All weights, specifications and features are approximate and are subject to change without notice. Due to continuous product improvements, product images may not be exact. Warning labels in some product...

Table of Contents