Intex Saltwater System CS8111 Owner's Manual page 21

SALTWATER SYSTEM OPERATION
1. Start up the unit:
Plug the power cord into the electrical outlet and test the
GFCI/RCD (circuit breaker). Switch on the unit.
With the Filter Pump turned "ON" and operating. The
green "Pump" light on the control panel will be on
and flashing code "00" appears on the electronic control
station's LED, indicating that the unit is ready to be
programmed. This is normal.
2. Set operating hours for Saltwater System:
With code "00" flashing, press
set the desired operating hours. See the
"Operating Time Table" for the required
operating hours related to each pool size.
Pressing will increase the time from 01
to 12 hours maximum. If you have selected
too many hours keep pressing
the cycle. The built-in timer will now activate
your Saltwater System, at the same time each
day, for the number of hours you have set.
NOTE: The Saltwater System will not operate if the filter
pump is not operating.
3. Lock keypad controls:
With the desired hour value showing, press
until you hear a "beep". The green "WORKING" indicator on the
control panel will light up within a few seconds to indicate that
the saltwater system has started sanitizer production. Locking
the control buttons into this setting prevents unauthorized
changing of the operating cycle.
NOTE: If you forget to lock the keypad controls, the system will
automatically lock it and start working 1 minute later.
4. Unlock & Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary.
Press button until you hear a "beep" to unlock the keypad
and the current programmed time will flash. Repeat steps 2 to 3.
5. Test the copper concentration in the
pool water.
The Saltwater System recommends a
copper level of 0.1 to 0.2 ppm. This is
easily tested by the copper ion test strips
provided. If the test result is 0.1~0.2ppm,
go directly to step 7.
SAVE THESE INSTRUCTIONS
(133) MODEL CS8111 SALTWATER SYSTEM & FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 11/17/2011
button to
to repeat
(1 to 12 hours max per cycle)
button
Copper (ppm)
0 0.1 0.2 0.5 0.9
OK
English
133
1.3
Page 21