Using The Adjustment Feet; Reversed Image Setup - Sharp XG - P10XU Operation Manual

Setting up the Screen

Using the Adjustment Feet

1
Press foot releases.
• The projector is adjustable up to approximately 5° from the standard position.
• When the height of the projector is adjusted, the image may become distorted (keystoned), depending on the relative
positions of the projector and the screen.
CAUTION
• Do not press the foot releases when the adjustment feet are extended without firmly holding the projector.
• Do not hold the lens when lifting or lowering the projector.
• When lowering the projector, be careful not to get your fingers caught in the area between the adjustment feet and the
projector.

Reversed Image Setup

Rear projection
• Place a translucent screen between the projector and
the audience.
• Use the projector's menu system to reverse the
projected image. (See page 42 for use of this
function.)
• Optimal image quality can be achieved when the projector is positioned perpendicular to the screen with all feet flat and
level.
CAUTION
• When using a mirror, be sure to carefully position both the projector and the mirror so the light does not shine into the eyes of
the audience.
Ceiling-mount Setup
• It is recommended that you use the optional Sharp ceiling-
mount bracket for this installation.
• Before mounting the projector, contact your nearest Authorized
Sharp Industrial LCD Products Dealer or Service Center to
obtain the recommended ceiling-mount bracket (sold
separately). (AN-XGCM61 ceiling-mount bracket, AN-
EP101AP extension tube for AN-XGCM61.)
• When the projector is in the inverted position, use the upper
edge of the screen as the base line.
• Use the projector's menu system to select the appropriate
projection mode. (See page 42 for use of this function.)
E-19
2
Adjust height of projector
and remove hands from foot
releases.
Projection using a mirror
• When the distance between the projector and screen
is not sufficient for normal rear projection, you can
use a mirror to reflect the image onto the screen.
• Place a mirror (normal flat type) in front of the lens.
• Project the normal image onto the mirror.
• The image reflected from the mirror is projected onto
the translucent screen.
3
Rotate feet to make minor
changes.