BenQ CinePrime W2700 User Manual page 36

10. Tighten the screw(s) that secures the lamp.
11. Ensure the handle is fully laid flat and locked in place.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screw.
12. Connect the lamp connector.
13. Put the safety mylar back to the top.
14. Replace the lamp cover on the projector.
15. Tighten the screw that secures the lamp cover.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screw.
16. .Connect the power and restart the projector.
Resetting the lamp timer
17. After the startup logo, open the On-Screen Display
(OSD) menu. Go to SYSTEM SETUP: ADVANCED Menu > Lamp Settings and press OK.
The Lamp Settings page appears. Highlight Reset Lamp Timer and press OK. A warning
message is displayed asking if you want to reset the lamp timer. Highlight Reset and press OK. The
lamp time will be reset to "0".
Do not reset if the lamp is not new or replaced as this could cause damage.
36 Maintenance
10
11
13
12