BenQ CinePrime W2700 User Manual page 10

11. SOUND MODE
Displays the SOUND MODE menu.
12. Picture quality adjustment keys (BRIGHT,
CONTRAST, COLOR TEMP, COLOR
MANAGE, GAMMA, SHARP)
Displays the setting bars for adjustments of the
appropriate picture quality values.
13. DYNAMIC IRIS
Enables or Disables the Dynamic Iris.
14. LIGHT MODE
Selects a suitable lamp power from among the
provided modes.
15. LIGHT
Turns on the remote control backlight for a
few seconds. To keep the backlight on, press
any other key while the backlight is on. Press
the key again to turn the backlight off.
16. DEFAULT
Resets to default value for all of adjustment
bars menu when doing adjustment.
17. TEST PATTERN
Displays the TEST PATTERN.
Remote control effective range
The remote control must be held at an angle within 30 degrees perpendicular to the projector's IR
remote control sensor(s) to function correctly. The distance between the remote control and the
sensor(s) should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor(s) on the
projector that might obstruct the infra-red beam.
• Operating the projector from the front
10 Introduction
18. CINEMA MASTER
Displays the CinemaMaster menu. See
CinemaMaster on page
19. HDR
Displays the HDR menu.
20. Volume keys
Decreases or increases the projector volume.
21. 3D
Displays the 3D menu.
22. PIC MODE
Displays the Picture Mode menu.
When Keystone OSD pops up, long press
for 2 seconds to enable Auto Keystone.
23. ECO BLANK
Used to hide the screen picture.
Do not block the projection lens from
projecting as this could cause the blocking
object to become heated and deformed or
even cause a fire.
• Operating the projector from the top
26.
/