Connect The Rs-232 Serial Cable; Perform Registration - IPWireless AP Broadband modem User Manual

Connect the RS-232 Serial Cable

1. Plug the 20-pin connector on the serial cable into the PC port located on the side
of the modem as shown in Figure 7.
2. Connect the other end of the serial cable into an RS-232 serial port on your
computer. If needed, refer to your computer manual for the location of a serial
port.

Perform Registration

You are now ready to register your user information. Please note: You can complete
the registration process at a later time; however User Registration is not optional. You
must register in order to create a username and password, register your account and
payment information, and receive software and modem upgrades.
Note: In order for the registration process to complete successfully, your browser
application must accept 'cookies'. If you have disabled cookies, enable them before
registration. If you wish, you may disable receipt of cookies after registration. See
Frequently Asked Questions (FAQs) in Appendix C for instructions on how to set cookie
preferences on your browser.
1. To Continue with Registration Now - Make sure that there is a check mark to
the left of Connect to [IPWireless] Now and then click 'Next'.
2. The Internet browser that you selected previously will launch and display the
New Customer Registration web page on the [IPWireless] Registration web
site. Note: If a connection cannot be made, the [IPWireless] PC Software will
timeout and display a message indicating that the connection failed. If this
happens, see the Troubleshooting Tips in Appendix A.
3. New Customer Registration - The [IPWireless] PC Software will connect to the
[IPWireless] Registration web page and prompt you to create a new account.
Figure 9
[ I P Wi r e l e s s ] B r o a d b a n d M o d e m U s e r G u i d e – D r a f t v . 3
2 4