Find The Best Radio Signal - IPWireless AP Broadband modem User Manual

Note :
Before connecting your [IPWireless] Broadband Modem to a power
source in the next step, you may want to consider using a power surge protector.
A surge protector is designed to protect electronic devices from electrical surges
and lightning strikes that may damage your computer or modem. If you don't
have a surge protector, contact your local computer or electronics retailer for
further details.
2. Plug the AC power adapter into a 120V or 240V AC power outlet.

Find the Best Radio Signal

1. Place the [IPWireless] Broadband Modem near your computer and press the
power button for one second to turn it on.
2. Your [IPWireless] Broadband Modem will perform a short self-test that will
last for approximately five seconds. The [IPWireless] Broadband Modem
will search for the best radio signal and then display the signal strength on
the inner center of the modem display.
3. When the self-test is complete, the power and battery indicators on the
display will illuminate. If these indicators flash on and off, there may be a
problem with the [IPWireless] Broadband Modem. Call [IPWireless]
Technical Support. Note: The display will dim after two minutes to conserve
battery life -- this is normal. A momentary press of the power button will
restore the brightness of the display.
4. The [IPWireless] Broadband Modem will 'search' for a base station, in a
manner similar to a cellular phone. When the modem is searching, the four
outside spirals in the center of the display will illuminate in a clockwise
direction. Each spiral will illuminate for one second on and three seconds off
during the base station search process.
Figure 3
[ I P Wi r e l e s s ] B r o a d b a n d M o d e m U s e r G u i d e – D r a f t v . 3
1 6