Change The System Settings; Reset An Alarm - Munters ComDry Supplemental Operating Instructions

ComDry Control System

1.11 Change the system settings

To change settings you must have "one-star" access, see 1.10, Access the control system .
Follow these steps to change the system settings:
Step Action
1
Navigate to the parameter you want to change by using
2
Press .
3
Change the value with
4
Confirm the new setting with
NOTE!
If the new setting is not confirmed within 30 seconds, the display changes back to the old setting.
NOTE!
Read-only values are not changeable. They will not start to flash if
level. To find out if a parameter is changeable or read-only, see section 2, Menus and parameters.

1.12 Reset an alarm

Follow these steps to reset an alarm:
Step Action
1 Write down the alarm message before resetting the alarm. The
information can be helpful when troubleshooting.
2 Wait until the dehumidifier has stopped.
Press .
3
Toggle [NO] to [YES] by pressing either
Confirm by pressing
NOTE!
If the cause of an alarm is still present, the alarm can reappear after resetting, even if the dehumidifier
is stopped.
MEN-CDCS-A1808
and .
.
or .
.
Operation
Result/Illustration
or .
The setting starts to flash.
The setting stops to flash.
is pressed, regardless of access
Result/Illustration
The display changes to
[Rst NO]and [NO] is flashing.
When the alarm has been reset, the
menu system returns to its start position.
7