Re-Threading Loopers; Re-Threading Needles - Baby Lock Acclaim BLES4 Instruction And Reference Manual

Re-threading Loopers

If a thread breaks, raise the presser foot and pull the broken thread out from under the foot. Open
the front cover and engage the threading lever. (page 18) Re-thread the machine above the
threading port, leaving an 18-inch (45cm) thread tail. Thread the looper as usual then engage the
threading lever to the serging position. (page 18/19) Close the front cover and sew a test sample.
Note: When re-threading your Baby Lock Acclaim using the "RevolutionAir Threading" feature,
make sure that the previous thread that was in the looper (tube) is completely removed. This will
eliminate any chance of the previous thread obstructing the flow of the air when re-threading the
machine.

Re-threading Needles

If a needle thread breaks, raise the presser foot, remove the broken thread and rethread the
needle thread guides. Use the "RevolutionAir Threading" feature for quick and easier threading.
Refer to pages 21 or 22 for further information.
T
H
R
E
A
D
I
N
G
24