Rf Exposure Information - IKEA TRADFRI Manual

— This equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the quipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
— Reorient or relocate the receiving
antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.

RF EXPOSURE INFORMATION

According to RF exposure regulations,
under normal operations the end user
shall refrain from being closer than 20 cm
from the device.
a. the device for operation in the band
5150–5250 MHz is only for indoor use
to reduce the potential for harmful
interference to co-channel mobile
satellite systems;
[Reference: RSS-247 Section 6.4 (5) (i)]
b high-power radars are allocated as
primary users (i.e. priority users) of the
bands 5250-5350 MHz and 5650-5850
MHz and that these radars could cause
interference and/or damage to LE-LAN
devices.
[Reference: RSS-247 Section 6.4 (6)]
7