Table of Contents
Advertisement
TELEVAC
INSTRUMENT MANUAL
VACUUM GAUGE MODEL MM200
UP/DOWN ARROWS
Below each display is a pair of pushbuttons with UP/ DOWN arrows. During normal operation, these pushbuttons
are used to change the station number being displayed. In this case they do not have any effect on the operation
of the instrument as such, they only affect which station is being displayed. The function of the UP/DOWN arrows
during setup is described below.
SETUP PUSHBUTTON
The SETUP pushbutton is used to control functions. They are controlled in the following sequence:
1. Cold Cathode gauge setup
2. Hot Cathode gauge setup
3. Relay setpoints/assignment
If module is not present, the corresponding step is skipped.
1a. COLD CATHODE SETUP (For Software Version 1.29* )
Press SETUP
Normally CC is left in this Auto mode.
Press UP-ARROW
CC is on whenever unit is on.
Press DOWN- ARROW
CC is off. Should return unit to Auto mode.
* Use with 7B2 & 7E cold cathode modules 2-6200-227 or -223.
160Phone:(215) 947-2500 fax:(215) 947-7464 e-mail:sales@televac.com
(for versions 2.31 or higher, refer to Section 6.2, page 602)
MM-200_im REV M
Page 56 of 160
- if module is present
- if module is present
- if module is present
.
.
.
web site:www.televac.com
Advertisement
Table of Contents
