Spectrum 55263 Assembly Instructions

Media director v2 flip-up shelf

Assembly Instructions:

(4) 052605

1/4-20 x 15mm JC Bolt

(8) 026073

(1) 039622

#8 x 3/4" PHSM

2" Grommet

Before you begin, please make sure all parts and proper quantities are

included. Any parts damaged during shipment must be reported within

5 days of receipt. To report information regarding damages or if you

have any questions, please call 1-800-235-1262.

Attach Folding Brackets to Shelf Support

A. Attach the (2) Folding Brackets to the Shelf Support with (6) 8-32 x 1/2" PHM Screws and Locknuts (3 per bracket) as shown in Figure 1.

Tighten securely.

Folding Bracket

8-32 x 1/2" PHMS

(3 per Bracket)

(6) 021587

(6) 029019

8-32 x 1/2" PHMS

8-32 Locknut

Tools Required:

Phillips Screwdriver

Adjustable Wrench

Media Director V2 Flip-Up Shelf

#55263

8-32 Locknut

Shelf Support

Figure 1

0103308X Page 1 of 2

Table of Contents

Do you have a question about the 55263 and is the answer not in the manual?

Page 1 Before you begin, please make sure all parts and proper quantities are included. Any parts damaged during shipment must be reported within #55263 5 days of receipt. To report information regarding damages or if you have any questions, please call 1-800-235-1262.
Page 2 Attach Shelf Support/Bracket Assembly to the Lectern A. Determine the preferred side of the lectern to locate the shelf. B. Attach the Shelf Support/Bracket Assembly to the Lectern using (4) 1/4-20 x 15mm JC Bolts. This assembly can be mounted at several different heights depending on the application.