Maintenance And Servicing; Inspection, Maintenance, And Cleaning; Please Read The Following Carefully - Central Pneumatic 98635 Set Up And Operating Instructions Manual

MAIntEnAnCE And
SERVICInG
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FROM ACCIdEntAL
OPERAtIOn:
turn the Power Switch (60) of
the Compressor to its "OFF"
position and unplug the unit
from its electrical outlet
before performing any
inspection, maintenance, or
cleaning procedures.
tO PREVEnt SERIOuS
InjuRY FROM tOOL
FAILuRE:
do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Inspection, Maintenance, and
Cleaning
1. BEFORE EACH USE, inspect the
general condition of the Compressor.
Check for loose screws, misalignment
or binding of moving parts, cracked or
broken parts, damaged air hose, and
any other condition that may affect its
safe operation.
2. BEFORE EACH USE, check the
compressor oil level in the Oil Sight
Glass (23). If necessary, fill the Com-
pressor's Crankcase with the proper
amount and type of compressor oil.
SKU 98635
tO PREVEnt
SERIOuS InjuRY
For technical questions, please call 1-800-444-3353.
3. DAILY, purge the Compressor's Tank
(1) of all air and moisture to prevent
corrosion. Carefully unscrew (no
more than two turns) the Drain Valve
(53) until the compressed air and
moisture begins to be discharged
from the Tank. Allow sufficient time
for all of the air and moisture to
escape from the Tank. Then firmly
retighten the Drain Valve.
4. AFTER USE,
of the tool with clean cloth and mild
detergent. Do not use solvents. Do
not immersed any part of the Com-
pressor in liquid.
5. WARnInG! If the Power Cord
(67) of this Compressor is dam-
aged, it must be replaced only by a
qualified service technician.
PLEASE REAd tHE
FOLLOWInG CAREFuLLY
THE MANUFACTURER AND/OR DISTRIBUTOR
HAS PROVIDED THE PARTS LIST AND
ASSEMBLy DIAGRAM IN THIS MANUAL AS
A REFERENCE TOOL ONLY. NEITHER THE
MANUFACTURER OR DISTRIBUTOR MAkES
ANY REPRESENTATION OR WARRANTY OF
ANy kIND TO THE BUyER THAT HE OR SHE
IS QUALIFIED TO MAKE ANY REPAIRS TO THE
PRODUCT, OR THAT HE OR SHE IS QUALIFIED
TO REPLACE ANY PARTS OF THE PRODUCT.
IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR ExPRESSLy STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAkEN By CERTIFIED
AND LICENSED TECHNICIANS, AND NOT By
THE BUyER. THE BUyER ASSUMES ALL RISk
AND LIABILITy ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
clean external surfaces
Page 12