Ds-Ttl Photography - Sea & Sea YS-01 Instruction Manual

Taking Photographs

DS-TTL photography

The DS-TTL system on this strobe is a slave TTL system with
flash dimming functionality. This system is useful for when
you are using another main strobe that can pre-flash such as
a camera's built-in TTL flash or another TTL strobe that is
connected to the camera.
1
Set the mode switch to [TTL], and set the light level
control dial to [FULL]
2
Take a photography
3
Adjust the light level with the light level control dial to
decrease the amount of light for exposure if you get
an overexposed image
CAUTION
DS-TTL mode is activated only when you are using a camera's
built-in flash or other TTL strobe connected to the camera. Use
this storbe as a sub-strobe of the main strobe. DS-TTL can not
be used if the main strobe (camera's built-in flash) is not equipped
with the TTL function, or if the main strobe (camera's built-in
flash) dose not pre-flash.
When you shoot, set the built-in flash of the camera to the
forced-flash mode. The strobe will not fire unless the built-in
flash of the camera fires.
You cannot increase the light amount with the light level control
dial higher than that the camera has detected.
E-19