Target Light Switch - Sea & Sea YS-01 Instruction Manual

Identification of Parts
Light level control dial
Light amount can be adjusted in 10
increments when the mode switch is
set to [ ] or [ ]. Marks can be used
to verify 1/4 ( ) or 1/2 ( ) of full flash.
In DS-TTL mode you can micro-adjust
(dimming only) the light amount.

Target light switch

The target light turns on when you
push the target light switch. The
target light turns off when you push
the switch once again.
The target light turns off when the
strobe fires, and lights up again when
the strobe is ready to fire (when the
Ready lamp illuminates in red).
CAUTION
The target light continues to be illuminated until pushing the swith,
setting the mode switch to [OFF], or until the power turns off
automatically (auto power-off).
The target light will flicker when the batteries get low, this is not
a malfunction.
E-11
TTL
MIN
FULL
Push