Connecting the Strobe
When you use this strobe, connect the strobe to the camera
(housing) with a fiber-optic cable (optional). Using a built-in
slave sensor, this strobe is triggered by sensing the light from
a digital camera's built-in flash. If the fiber-optic cable is not
used, depending on the shooting conditions the strobe may
either not fire, or not obtain DS-TTL flash exposure compensation.
CAUTION
Some housing are not compatible with fiber-optic cable.
1
Insert the fiber-optic cable's
connector into the fiber-optic
cable socket (slave sensor) of
the strobe until it stops
When inserting the fiber-optic cable
into the socket for additional strobe,
the strobe will not fire correctly.
Please refer to page E-16 for
details.
2
Secure the fiber-optic cable
with the fiber-optic cable hook
3
Connect the fiber-optic cable's
connector to the socket in the
housing
When the housing is not equipped
with the socket, attach the optional
strobe mask (A) to the flash window
of the housing, and then connect
the fiber-optic cable (B).
E-15
Fiber-optic cable hook
B
A