Operation - Sea & Sea YS-01 Instruction Manual

Operation

Mode Switch
Turns the power off. Set the
OFF
mode switch to [OFF] when
you are not using the strobe.
Set the mode switch to this
position when you shoot with
manual flash using a digital
camera that pre-flashes.
Set the mode switch to this
position when you shoot with manual flash using a
digital camera that does not pre-flashes.
Set the mode switch to this position when you shoot
TTL
with DS-TTL flash.
Pre-flash
With some types of digital cameras, the light amount is adjusted
with the first flash and the image is taken with the second flash
(main flash). The first flash for adjusting the light amount is called
a pre-flash. With the normal slave function, the strobe will fire
in synchronization with the pre-flash. As a result, it will recharge
during the second flash (main flash) and be unable to fire.
CAUTION
The number of times a digital camera's built-in flash will fire differs
among models. Depending on the number of pre-flashes mode
switch settings can differ, so check settings before shooting by
conducting test flashes.
When 30 minutes has passed from turning on the power, or last
emission of the strobe, the power will turn off automatically (auto
power-off). When turning on the power again, set the mode switch
to [OFF] before setting the desired mode.
Identification of Parts
OFF
TTL
MIN
E-10
FULL