Read And Verification Error Messages - Siemens SIMATIC MV540 H Operating Instructions Manual

10.1.4

Read and verification error messages

If a read error or verification error occurs, the following error codes and error messages are
output. You can find additional information in the section "Overall result" of the online help.
Note
The causes of error 4700 to 4722 are also output in the verification report if there is a
verification error
All verification grades are output in the report as "E". The verification values correspond to
the error code.
Note
Evaluating verification errors as read errors
If the "Evaluate quality 'Poor' as "N_OK" check box has been selected in the decoding
settings, a verification error will also be evaluated as "N_OK".
Table 10- 3 Read/verification error messages
Error code Error message
(%c) (%s)
0001 No 1D/2D code found in step n
0002 Cycletime too short
0003 Trigger too fast
0004 Non ECC200 Code in step n
0005 Step n: Structured Append DMC not supported
0006 Step n: Reader Programming DMC not supported In step #n, a "Reader Programming Code" DMC type
0007 Step n: QR ECI encoding not supported
0008 Step n: QR Byte encoding not supported
0009 Step n: QR Kanji encoding not supported
0010 Step n: Structured Append QR code not support-
ed
0011 Step n: QR FNC1 encoding not supported
0012 Code quality is poor in step n
SIMATIC MV500
Operating Instructions, 06/2018, C79000-G8976-C494-01
10.1 Error and diagnostics messages
Description
No code was found in step #n.
The processing was not completed within the cycle
time limit.
The processing was interrupted by a trigger signal.
A data matrix code was found in step #n that does not
correspond to ECC200.
Note:
The check for ECC200 is performed only in adjust-
ment mode and during "Save program".
In step #n, a "Structured Append" DMC type was
found. This DMC type is not supported.
was found. This DMC type is not supported.
In step #n, a QR code with "ECI encoding" was found.
This QR type is not supported.
In step #n, a QR code with "Byte encoding" was
found. This QR type is not supported.
In step #n, a QR code with "Kanji encoding" was
found. This QR type is not supported.
In step #n, a "Structured Append" QR type was found.
This QR type is not supported.
In step #n, a QR code with "FNC1 encoding" was
found. This QR type is not supported.
A code with "poor" quality evaluation was read in
step #n during verification.
Service and maintenance
181