Motorola PM1500 User Manual page 68

Annunciator Indication
K View/Program Mode
The radio is in the view or program
mode. (flashing for program mode;
solid for view mode.)
C In-Call User Alert
Voice muting has been activated as
radio is receiving.
GENERAL FEATURES
Selecting Transmit Power Level
1 Press button below PWR
The display shows HIGH PWR or LOW PWR.
2 If HIGH PWR was selected previously, pressing the
softkey will display LOW PWR and low power
indicators will come on.
3 If LOW PWR was selected previously, pressing the
softkey will display HIGH PWR and high power
indicators will come on.
Sending an Emergency Alarm
1 Press and hold the preprogrammed emergency
button (T1). The red LED lights steadily. You hear an
emergency tone. The display alternately shows
EMERGNCY and the current zone and mode names.
When the alarm is acknowledged by the dispatcher,
you hear four beeps. The radio returns to normal
operation.
Cancelling an Emergency Alarm
1 Press and hold the preprogrammed emergency
button (T1) before the alarm is acknowledged. You
hear an exit tone and the radio returns to normal
operation. If the radio does not return to normal
operation, press the PTT button. The radio does not
sound an exit tone.
Sending an Emergency Call
1 Press and hold the preprogrammed emergency
button (T1). The red LED lights steadily. You hear a
short, medium-pitched emergency tone. The display
alternately shows EMERGNCY and the current zone and
mode names.
2 Press the PTT button and announce your emergency.
3 To exit the emergency call mode, press the
emergency button for a little over 1-1/2 seconds (or for
the duration specified by your system manager). You
hear a medium-pitched exit tone and the radio returns
to normal operation.
Muting Keypad Tones
D
1 Press the below MUTE.
2 The display shows X TONES if previously TONES was
selected and vice versa.
SCANNING
Turning Scan On or Off
D
1 Press the below MUTE.
Alternatively, press the preprogrammed Scan button.
2 The display shows SCAN ON or SCAN OFF.
Activating SCAN ON will turn on the scan indicator.
Deleting Nuisance Modes
1 When the radio is locked onto the mode you want to
delete, press the NUIS softkey. Alternately, press the
preprogrammed Nuisance Delete button. The mode is
deleted and you hear a valid key-press chirp.
2 To resume scanning the delete mode, turn scan off
and then back on again.
Programming a List
D
1 Press the below PROG until the display shows the
softkey options.
D
2 Press the below the type of list you wish to
access. The display shows a flashing
3 Rotate Mode Knob until you reach the list entry you
wish to edit, or enter the number of the item in the list
using the keypad.
4 Press the NAME or NUM softkey to edit.
5 Use the numeric keypad to modify the entry.
6 Press the SAVE softkey to save your changes.
7 Press EXIT to exit programming mode and return to
the home display.
SELECTIVE CALL AND CALL ALERT
Calling or Paging the Last ID Number
Transmitted or Received
1 Press the CALL (of PAGE for Call Alert softkey.
2 The display shows the last ID transmitted or received.
In the case of Selective Call, the display shows the ID
number .
3 Proceed to step 1 of "Send a Selective Call" or "Send
a Call Alert Page".
Directly Entering ID Number to be Called/Paged
1 Press the CALL (of PAGE for Call Alert softkey.
2 The display shows the last ID transmitted or received.
In the case of Selective Call, the display shows the ID
number .
3 Use the numeric keypad to enter the new ID number.
4 Proceed to step 1 of "Send a Selective Call" or "Send
a Call Alert Page".
K
indicator.