Updating Game Code For The S.a.m. System - Stern Pinball AC/DC Service And Operation Manual

SETUP AND MOVING

1.7 UPDATING GAME CODE FOR THE S.A.M. SYSTEM

Game code is subject to change. Update this game with the latest code downloaded from our website, from another game, or order
from your local distributor.
Upon powering up, the display will describe the version of code installed in your game. When directed to do so (via Service Bulletin or
website announcment) you will need to update your code with the boot flash EPROM installed, here's how:
STEP 1
Open the backbox and locate the 8-position DIP switch (SW1 on
the CPI/Sound board)
STEP 2
Switch DIP switch #8 to 'ON' (Boot flash EPROM must be in-
stalled)
STEP 3
Press the white reset button (S1 RESET on the CPU/Sound
board) or power cycle the game OFF/ON (ON/OFF switch is
located on the outside of the cabinet bottom, front right).
STEP 4
Using the 4-button service switch set (inside the coin door):
4A: Press [SELECT] to begin.
4B: With the "UPDT" icon highlighted, press [SELECT].
4C: Insert the memory stick (with the latest files) into the USB
port.
4D: If more than one file is present on the memory stick, press [<]
or [>] to locate your file. Press [SELECT] to update.
4E: Follow on-screen prompts.
CPU/SOUND BOARD (S.A.M. SYSTEM)
12
AC/DC LUCI MANUAL 500-55C8-01
Green Button Red Buttons
Press to escape Press to move <Left, Right>.
back (or exit) Press to - Decrease or +
Increase values or to change
settings.