scope R4C Maintenance Manual page 18

REAR
WHEEL
5
Gently tighten the bearing removal tool and
assure its correct position on the bearing.
6
Tighten the bearing removal tool until the
bearing is fully seated.
7
Check the alignment to make sure the bearings
run smoothly.
8
Insert the axle into the hub (11).
9
Carefully place the other bearing (13) in the
bearing seat on the non-drive side without
applying pressure.
10
Repeat steps 3-7 but do not use the 15mm
guide (T9).
11
Place the freehub spacer (7) on axle drive side.
12
Place the long 1524/1528 (T5) presshead and
the 15mm guide (T9) on the bearing removal
tool (T1&T2) with the 1524 side facing the hub.
18