Removing The Bearings - scope R4C Maintenance Manual

REAR
WHEEL

REMOVING THE BEARINGS

To remove the bearings you'll need the following tools:
• Bearing Removal Tool (T1/T2/T3)
• 1x Plastic Presshead (T6)
• Large Spacer (T9)
• Small Spacer (T8)
1
Remove the freehub and hub cap from the
hub by pulling it off the axle.
2
Remove the freehub spacer from the axle.
3
Pull off the non-drive side hub cap by hand.
4
Place a small threaded plastic presshead (T6)
on the bearing removal tool (T1&T2) and insert
the tool into the axle from the drive side of the
hub.
5
Place the small spacer (T8) on opposite side
of the hub and screw on the bearing removal
tool handle (T3).
6
Gently tighten until the bearing is released.
7
Take the hub axle (11) turn it around and place
it into the non-drive side of the hub.
15