Replacing The Bearings - scope R4C Maintenance Manual

REAR
WHEEL

REPLACING THE BEARINGS

To replace the bearings you'll need the following tools:
• Bearing removal tool (T1/T2/T3)
• Long press head 1524/1528 (T4)
• Short press head (1524/1528 (T5)
• 15mm guide (T9)
1
Apply a small amount of grease onto both
bearing seats of the hub.
2
Carefully place one bearing (2) on the bearing
seat on the drive-side without applying pressure.
3
Place the long 1524/1528 (T5) presshead and
the 15mm guide (T9) on the bearing removal
tool (T1&T2) with the 1524 side facing the hub.
4
Slide the tool into the hub and place the short
1524/1528 (T5) presshead on the opposite side,
then screw on the handle (T3).
17