Color Kinetics iPlayer 3 User Manual page 11

2. Connect the cable end with the 4-pin leads into the back of the
Controller Keypad.
3. Connect the cable end with the DB9 cable connector to serial port 1 or 2 on
iPlayer 3.
4. As needed, set the Range switch position on the back of the keypad. By
default, switch position 0 (zero) sets the keypad to trigger shows 1 – 8 (see
"About Show Ranges" on page 18 for an overview of trigger ranges).
Power on the iPlayer 3.
5.
To connect an AuxBox:
1. Power off the iPlayer 3.
2. Connect the female end of the serial cable to the AuxBox serial port.
3. Connect the male end with of the serial cable to serial port 1 or 2 on iPlayer 3.
As needed, set the Range switch position on the front of the AuxBox. By
4.
default, switch position 0 (zero) sets the AuxBox to trigger shows 1 – 8.
Connect each external triggering device's two-wire cable to a terminal pair on
5.
the AuxBox.
Connect the 24 VDC power cable to the 24 VDC terminals on the AuxBox, and
6.
then plug it in.
Power on the iPlayer 3.
7.
Step 8: Connect lighting systems with RJ-45
data cable
DMX 1
Control to Lights
DMX 2
Control to Lights
DMX output port 1 manages light universe 1 (light addresses 1-170)
DMX output port 2 managed light universe 2 (light addresses 1-170)
Step 9: Create and download light shows via
ColorPlay 3
iPlayer 3 User Guide 7