8
ASSEMBLING AND PREPARING
CAUTION
Always use genuine components to ensure safety and product performance.
•
The product warranty will not cover damage or injury caused by the use of counterfeit components.
•
Connect the power cord to the product before you plug it into a wall outlet. Plugging the power cord into a wall
•
outlet first may cause an electric shock, which can damage the product.
When installing or using this product, be cautious of damaging the product or safety accident due to negligence.
•
If you do not fully understand the instructions in this manual, do not install the product and contact the service
•
center.
Check the accessories provided with the model before installation. We will not be responsible for missing or damaged
•
accessories after the internal packaging is damaged.
The colored, transparent film should be stored upside down with its LED hole facing up.
•
Keep out of reach of children, as various safety accidents such as suffocation can occur if an infant or child swallows
•
the accessories provided with the product.
Make sure that the screws are completely tightened.
•
Tightening the screws with excessive force may damage the wall, degrade the performance and solidity of the
•
product, or damage the product.
Do not install display products that are heavier than the designated weight and make sure that external force is not
•
applied.
Be cautious of safety accidents when handling tools for installing the product.
•
Before installation, remove accessories (watch, bracelet, etc.) that can damage the colored, transparent film.
•
Applying excessive force may damage the product.
•
There is no problem if fine bubbles are not visible to the naked eye at a distance of 1 m (3.2 feet) from the light-
•
emitting surface of the product.
NOTE
The accessories provided with your product may vary depending on the model.
•
Product specifications or contents in this manual may be changed without prior notice due to upgrade of product
•
functions.
The warranty will not cover any damage caused by using the product in an excessively dusty environment.
•
Up to 4 films are supported per 210 W adapter.
•
Up to 18 1st bezels can be connected to one LAN port.
•
Up to 26 common bezels can be supported per 1st bezel board.
•
For adapter cable extension, use an approved standard cable.
•