WARNING
The warranty will not cover any component damage caused by electrostatic discharge at the time of installation.
•
When installing this product, you must wear anti-electrostatic discharge (ESD) gear.
There should be no oil, water, dust and foreign substance on the glass surface where the colored, transparent LED
•
film will be installed.
Do not use surfactant-containing products for cleaning. It compromises the film's adhesive strength.
•
It is recommended that you use dedicated tools (for film attachment) when installing the film.
•
Workers should wear masks and antistatic gloves and be careful not to allow foreign objects to adhere to the product
•
or the glass surface.
The colored, transparent LED film should not be folded or wrinkled, and once attached, should not be separated from
•
the glass.
Be cautious when handling the colored, transparent LED film because it is vulnerable to static electricity and foreign
•
substances.
After opening the product, install it immediately or within 1 month at the latest.
•
Applying strong physical impact on the installed film surface may damage the product.
•
Required Items for Installation
Oil-based marker, mask, antistatic gloves, the Phillips-head screwdriver, wool putty knife, (steel) ruler
Installation Preparation
When attaching the aluminium bar, apply pressure to increase adhesive strength so that there is 1-2 mm (0.03-0.07
•
inches) gap between the aluminium bars. (Pressure: 5 kgf-7 kgf)
Remote Control Receiver
Because the product is the embedded-type, the remote control should be used only during installation and the use of
remote control by user is not recommended.
9