Sharp DV-RW550U Operation Manual page 37

If the timer program did not complete correctly, the error number appears on the timer pro-
gramming list.
Timer Programming
Date Start
* JAN/01 12:57AM
2. ---
3. ---
Each error number means:
E1-22 Recording error other than
E37-39 below
E23-24 Unrecordable disc
E25-28 Copy prohibited program
E29 Disc protected
E30 Disc full
E31-32 Already 99 titles recorded
E33 Already 999 chapters recorded
E34 No space for Control information
E35 PCA full
Explanation on the front panel indicator during Timer Recording
(CLOCK) mark
VCR mark
DVD mark
Note
• If the end of programmed time in DVD and a start of programmed time in VCR are the same, the indicator
of the front panel may not be switched from DVD to VCR automatically. However, the Timer Recording for VCR
is in progress normally. In such case, press OUTPUT SELECT on the front panel or VCR
control to activate the display.This is not a malfunction.
Recording
Timer Recording (cont'd)
Error number will appear
VCR DVD
DVD
End CH Speed
VCR
1:57AM 8 DVD E22
E36 Already finalized Video format
disc
E40 Some portion has not been
recorded because of program
overlapping. Recording did not
start at the start time.
No videotape is inserted.
Videotape ran out during
recording.
E41 Power failed
E42 No disc when recording
- An OTR is completed, and there is no other timer recordings in standby.
- The timer standby mode is cancelled by pressing T -SET.
Lights off
- POWER is pressed during timer standby, and the component that is not
in timer standby mode is turned on.
- The unit entered into the timer standby mode.
Lights on - A Timer Recording or an OTR has started.
- When this indicator is on, you cannot use SET UP.
- All timer recordings are completed.
Flashing
- All VCR Timer Recordings are completed, and there is no other timer
recordings in standby.
- A VCR Timer Recording is cancelled by pressing STOP/EJECT C/A on
the unit.
Lights off
- The VCR timer standby mode is cancelled by pressing T -SET.
- POWER is pressed during VCR timer standby, and the unit switched to
the DVD mode.
- The VCR entered into the timer standby mode.
Lights on
- The VCR entered into the timer standby mode when no tape or a tape
Flashing
without an erase protection tap is in the unit.
- The tape runs out during Timer Recording.
- All DVD Timer Recordings are completed, and there is no other timer
recordings in standby.
- The DVD timer standby mode is cancelled by pressing T-SET.only momentarily.
Lights off
- POWER is pressed during DVD timer standby, and the unit switched to the
VCR mode.
- The DVD entered into the timer standby mode.
Lights on
- The DVD entered into the timer standby mode when no disc or an
Flashing unrecordable disc is in the unit.
- The disc runs out of the space during Timer Recording.
Note
• A program with the error
number is highlighted in gray
of the asterisked line in the
timer programming list.
• Once the timer programming
list with error indication is dis-
played, the program line(s)
with error will be cleared only
after the programs are can-
celed and reset to the timer
standby mode.
• The current recording pro-
gram will be highlighted in red.
on the remote
37