Advertisement
Quick Links
Vertical Lift Door Opener Kit
Supplementary Installation
Manual for eDrive +2.0 Vertical
Lift Door Opener Kit
NOTE:
This document contains information for the installation of the
Vertical Lift Door Opener Kit which has been specifically
designed for vertical lift cool room doors.
This document must be read in conjunction with the Grifco
eDrive +2.0 User Manual which contains setup, operation and
safety information.
www.grifco.com.au
www.grifco.co.nz
D-M-RSO/037
Chamberlain Australia Pty Ltd
PO Box 1446, Lane Cove
NSW 1595, Australia
Phone toll free 1800 474 326
Chamberlain New Zealand Ltd
PO Box 100-221
North Shore 0745, New Zealand
Phone toll free 0800 653 667
160715
Advertisement
Related Manuals for Grifco eDrive +2.0
Summary of Contents for Grifco eDrive +2.0
- Page 1 This document contains information for the installation of the Vertical Lift Door Opener Kit which has been specifically designed for vertical lift cool room doors. This document must be read in conjunction with the Grifco eDrive +2.0 User Manual which contains setup, operation and Chamberlain Australia Pty Ltd safety information.
- Page 2 WARNING: The Grifco eDrive +2.0 User Manual contains important safety information and must be read prior to attempting installation of this opener.
- Page 3 Note: Left Hand installation shown Supplied hand chain not shown When replacing an existing non Grifco opener, it is recommended to follow these steps: 1. Clamp the mounting plate into position and use the 4 x M8 holes as a jig to drill through the installed idler bracket 2.
- Page 4 INSTALLATION – ELECTRICAL CONNECTIONS EXPANSION BOARD INSTALLATION: Refer to Expansion Board manual for mounting instructions. DIP SWITCH SETTINGS: Factory setting: Dip Switch #2 to ON, set all others to OFF Cable Number Relay Expansion Board (EB1) Main Control Board C10A (MCB) 1 (RJ6 cable supplied) Ethernet connector...
Need help?
Do you have a question about the eDrive +2.0 and is the answer not in the manual?
Questions and answers