A-Neuvideo ANI-42HPIP Instruction Manual page 13

A NEUVIDEO
OSD COMMANDS
COMMAND
GET OUT A OSD BANNER
DISPLAY 8
SET OUT A OSD BANNER
LOCATION N1 8
GET OUT A OSD BANNER
LOCATION 8
SET OUT A INFO LOGO
DISPLAY N1 8
NOTE: Enabling the graphic logo will automatically disable display of the info banner.
GET OUT A INFO LOGO
DISPLAY 8
SET OUT A INFO LOGO
HPOSITION N1 8
NOTE: The maximum value depends on, and cannot exceed, the current output resolution's width minus 1.
GET OUT A INFO LOGO
HPOSITION 8
SET OUT A INFO LOGO
VPOSITION N1 8
NOTE: The maximum value depends on, and cannot exceed, the current output resolution's height minus 1.
GET OUT A INFO LOGO
VPOSITION 8
AUDIO COMMANDS
COMMAND
SET AUDIO OUT A MUTE
N1 8
GET AUDIO OUT A MUTE 8
SET AUDIO OUT A ROUTE N1 8 Set Input N1 as the audio source to output.
GET AUDIO OUT A ROUTE 8 Show the current audio source.
SET AUDIO OUT A VOLUME
N1 8
GET AUDIO OUT A VOLUME 8 Show the current analog audio volume value.
SET AUDIO OUT A DELAY
N1 8
NOTE: The range provided is for 48KHz sources. Increasing the sample rate will reduce the maximum delay range.
GET AUDIO OUT A DELAY 8
DESCRIPTION
Show the current state of the OSD info banner
display.
Set the position of the OSD info banner.
Show the current position of the OSD info banner.
Enable or disable the graphic logo.
Show the current status of the graphic logo display.
Set the horizontal position of the top left corner of
the graphic logo (in pixels).
Show the graphic logo's current horizontal position.
Set the vertical position of the top left corner of the
graphic logo (in pixels).
Show the graphic logo's current vertical position.
DESCRIPTION
Enable or disable muting the audio output.
Show the current audio mute state.
Set or adjust the analog audio output volume.
Set the analog audio delay value (in milliseconds).
Show the current analog audio delay value.
RS-232 & Telnet Commands
VARIABLES
Available values for N1:
0
1
2
3
4
5
N1 = ON, OFF [Graphic logo state]
N1 = 0~?
N1 = 0~?
VARIABLES
Available values for N1:
OFF
ON
N1 = 1~4
Available values for N1:
0~100
UP
DOWN
N1 = 13~100
11
[Upper-left]
[Middle-left]
[Lower-left]
[Upper-right]
[Middle-right]
[Lower-right]
[Horizontal position]
[Vertical position]
[Un-muted]
[Muted]
[Input number]
[Set volume in dB units]
[Raise volume by 1]
[Lower volume by 1]
[Audio delay in ms]