Handling And Storage - Agilent Technologies 85056A User's And Service Manual

Use, Maintenance, and Care of the Devices

Handling and Storage

Figure 3-8 Sliding Load Set Marks
Handling and Storage
• Do install the protective end caps and store the calibration devices in the foam-lined
storage case when not in use.
• Do keep connectors clean.
• Do not touch mating plane surfaces. Natural skin oils and microscopic particles of dirt
are easily transferred to a connector interface and are very difficult to remove.
• Do not set connectors contact-end down on a hard surface. The plating and the mating
plane surfaces can be damaged if the interface comes in contact with any hard surface.
• Do not store connectors loose in a box, or in a desk or bench drawer. This is the most
common cause of connector damage during storage.
3-20 85056A