Console; Host Terminal Emulator Setup - Symmetricom 8040C User Manual

Console

The Symmetricom Serial Interface Protocol (SSIP) provides user
communication with the 8040C/8040CLN through the serial port when the unit
is connected to a host PC or terminal. All "developer-mode" commands are
single-letter format.

Host Terminal Emulator Setup

Set up the comm port of the PC with the following configuration:
All SSIP commands are a single ASCII letter. The baud rate of the
8040C/8040CLN is 57.6K.
Note: Requires a null modem cable (DTE).
15254-201.docx

Data rate (Baud/BPS - see note below)

No parity

8 data bits

1 stop bit

No local echo (unit echoes)

No hardware or software flow control
12
Rev. C, 07/12/2011