Watching The Playback On A Tv - Sharp VIEWCAM VL-A110U Operation Manual

Watching the Playback on a
TV
You can also connect the VIEWCAM to a TV to
allow a larger audience to enjoy video
playback.
1
Lift up the terminal cover on the
VIEWCAM ( ) and rotate it to the right
Q
( W ).
Terminal cover
2
Connect the VIEWCAM to your TV (or
VCR) with the supplied audio/video
cable, as shown.
Yellow: To VIDEO IN jack
White: To AUDIO IN (L) jack
CHANNEL
PAUSE
/STILL
PLAY
STOP/
EJECT
POWER
TV/VCR SET UP REC
Audio/video cable
(supplied)
To AUDIO/VIDEO jack
3
Turn on the TV and set it to the "AV" or
"VIDEO" channel. (See the operation
manual of your TV.)
• When connecting to a TV via a VCR, turn on
the VCR and set it to the "AV" or "LINE"
input channel. Operate the TV as you
normally do to see the signal from the VCR.
(See the operation manuals of your TV and
VCR.)
4
Turn on the VIEWCAM in VCR mode,
and begin tape playback (see page 21).
Caution:
• Make sure that the VIEWCAM, TV, VCR and other
equipment to be connected have been turned
off before you make connections. Making con-
nections with any of the components left turned
on may cause picture noise or a malfunction.
Notes:
• This VIEWCAM does not have an S-video
socket.
• When the VIEWCAM is connected to a TV for
playback, the picture on the TV screen may
flicker if the volume on the VIEWCAM is set to
maximum. Should this occur, turn the volume
down (see page 21).
• Close the terminal cover after use.
22