Recording The Date And Time - Sharp VIEWCAM VL-A110U Operation Manual

Recording the Date and Time

Follow the procedure shown below to record
the date and time, or the date only, along with
the subject.
Note:
• Before performing the procedure below, make
sure that the date and time have been correctly
set (see page 16).
1
In Recording Standby mode, press the
MENU button until
appears.
2
Press the PAGE button ( ) to display
MENU 2.
P A G E
3
Press the or
"DISPLAY".
S E T
4
Press the SET button (B) to select
"AUTO", "ON", or "OFF".
S E T
(MENU 1)
MENU 2
DAT E / T IME
D I S P L A Y O F F
+
S E L E C T DAT E T I ME
S E T T I NG JU N 2 2 0 0 1
1 0 3 0 AM
1 2H
1 2 H 2 4 H /
5
P I C -
S E T TURE PAGE
button to select
MENU 2
DAT E / T IME
D I S P L A Y O F F
+
S E L E C T DAT E T I ME
S E T T I NG JU N 2 2 0 0 1
1 0 3 0 AM
1 2H
1 2 H 2 4 H /
MENU 2
DA T E / T I ME
D I S P L A Y O F F
+
S E L E C T DA T E T I ME
When "AUTO" is selected, the date/time
is displayed and recorded for 10
seconds at the beginning of the first
recording of each day.
When "ON" is selected, the date/time is
continuously displayed and recorded.
When "OFF" is selected, the date/time is
neither displayed nor recorded.
Note: In "AUTO", if you wish to record the
date/time a second time that day, repeat the
procedure above and re-select "AUTO".
5
Press the button to select "SELECT".
S E T
6
Press the SET button (B) to select
"DATE+TIME" or "DATE".
S E T
When "DATE+TIME" is selected, both the
date and the time are displayed and
recorded.
When "DATE" is selected, only the date
is displayed and recorded.
7
Press the DISPLAY button to turn off the
menu screen, and then press the REC
START/STOP button to begin recording.
MENU 2
DATE / T IME
D I S P LAY AUTO
+
S E L E C T DATE T I ME
JU N 2 2 0 0 1
S E T T I NG
1 0 3 0 AM
1 2 H 2 4 H / 1 2H
MENU 2
DAT E / T IME
D I S P L A Y AUTO
+
S E L E C T DAT E T I ME
JU N 2 2 0 0 1
1 0 3 0 AM
26