GE Tetra GEPS24W-80M Installation Manual

GE
Lighting Solutions
Tetra LED Systems Power Supply
®
(GEPS24W-80M)
Power Supply Features
• Supports Tetra PowerStrip DS, Tetra miniStrip DS, Tetra EdgeStrip,
Tetra Contour and Tetra Contour LS LED lighting systems
• Class 2 wiring per NEC Article 725 (SELV)
• IP66 rated: wet location rated
• M20 Thread

BEFORE YOU BEGIN

Read these instructions completely and carefully.
RISK OF ELECTRIC SHOCK:
• Disconnect power at fuse box or circuit breaker before servicing or
installing product.
• Properly ground Tetra power supply.
®
RISK OF FIRE:
• Use only approved wire for input/output connection.
Minimum size 18 AWG (0.82 mm
• Follow all local codes.
Power Supply Installation
Power supply
input wires
Conduit
AC Line
Run AC line through conduit and
1
attach conduit to outdoor-rated
enclosure. Attach power supply to
enclosure.
imagination at work
WARNING/AVERTISSEMENT
)
2
NOTE: All electrical connections
Power supply
should be made within the letter.
White (-)
2
Connect the red stripe wire (+) of the
LED strip to the red wire (+) of the
power supply. Connect the white
wire (-) of the LED strip to the black
wire (-) of the power supply.
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l'alimentation électrique à la boîte de fusibles ou au
disjoncteur avant l'entretien ou l'installation du produit.
• Assurez-vous de correctement mettre à terre l'alimentation
électrique Tetra .
®
RISQUES D'INCENDIE
• N'utilisez que des fils approuvés pour les entrées/sorties de
connexion. Taille minimum 18 AWG (0.82 mm
• Respectez tous les codes locaux.
Red (+)
To power supply
Black (-)
Red stripe (+)
Connect the AC line to the brown
3
(line) and blue (neutral) input wires of
the power supply using 18-14 AWG
(0.82-2.08 mm
connectors. Properly ground (green
wire with yellow stripe) power supply
in accordance with National Electric
Code (NEC) Article 600.
Installation Guide
24
Volt
).
2
Blue (+)
Green with
yellow stripe
Brown (-)
) twist-on wire
2