Deep Sea Electronics Plc DSE6120 MKII Operator's Manual page 45

Icon Description
Auto Mode
This button places the module into its Auto Mode
module to control the function of the generator automatically. The module
monitors the remote start input and once a start request is made, the set is
automatically started and placed on load (Close Generator and Delayed Load
Output 1, 2, 3 & 4 become active in order from lowest to highest (if used)).
Upon removal of the starting signal, the module removes the load from the
generator and shut the set down observing the stop delay timer and cooling timer
as necessary (Close Generator and Delayed Load Output 1, 2, 3 & 4 become
inactive at once (if used)). The module then waits for the next start event.
For further details, please see section entitled Operation elsewhere in this manual.
Alarm Mute / Lamp Test
This button de-activates the audible alarm output (if configured) and illuminates all
of the LEDs on the module's facia.
Start
This button is only active in the Stop/Reset Mode
Test Mode
Pressing the Start
not start the engine. This can be used to check the status of the CAN
communication and to prime the fuel system.
Pressing the Start
generator and runs it off load in Manual Mode
Description Of Controls
.
button in Stop/Reset Mode
button in Manual Mode
Page 45 of 94
. This mode allows the
, Manual Mode
powers up the ECU but does
or Test Mode starts the
or on load in Test Mode
057-236 ISSUE: 1
and
.