Kenmore 796.6143 Series Use & Care Manual page 24

INSTALLATION INSTRUCTIONS
REVERSING THE DOOR SWING (continued)
c. Carefully lower the door cover into place, aligning
the holes in the cover with the 3 interlock buttons
and the bumpers on the bottom edge. You may
need to force fit the door cover.
d. Once the door cover is in place, secure it with the 12
screws removed in step 4.
NOTE:
ake sure the 3 interlock buttons are aligned with the
M
holes in the door cover.
Two different screws
NOTE:
10 similar screws are inserted in the top and sides of
the door cover. The 2 different screws are inserted in
the bottom edge.
14
Reassemble the door on the cabinet.
While supporting the door, insert the hinge support
into the slot in the door and slide the door down
slightly to seat it. Install the 4 hinge screws
removed in step 2. Test the swing of the door to
check the alignment of the hinges and latch. Make
sure the door opens, closes, and latches properly in
both directions.
Two large screws
Two small screws
If the door is damaged, or if the door does not work after
reassembly, contact the call center at 1-800-469-4663.
24