Kenmore 796.6143 Series Use & Care Manual page 22

INSTALLATION INSTRUCTIONS
REVERSING THE DOOR SWING (continued)
7
Lift out the gray interlock button in the side of the
door.
Make sure to remove the spring with the interlock
button and to keep the two together. Set the interlock
button aside. Do not confuse this with the interlock
buttons from the top of the outer door.
8
Remove the side lock rod.
Remove the side lock rod from the lower hinge bracket
by lifting the top end of the rod and sliding it toward
the top of the door. The spring should remain attached
to the lock rod. Set the lock rod aside.
9
Reverse the upper hinge assembly and hinge filler.
a. Remove the screw connecting the upper hinge
assembly to the top lock rod and set it aside.
b. Lift out the upper hinge filler (on the right) and set
it aside.
Spring
22
c. Lift out the upper hinge assembly (on the left).
d. Slide the upper lock rod to the right. Rotate the
upper hinge assembly 180 degrees, and install it
over the lock rod on the right, where you removed
the upper hinge filler. Press firmly to fully seat the
hinge assembly.
e. Rotate the hinge filler 180 degrees and install it on
the upper left side of the door.
f. Insert and tighten the screw connecting the upper
hinge assembly to the top lock rod, removed in
step a.
Assemble screw