Removal; G Removing A Misfeed; Removing A Misfeed - Sharp AR-M550N Operation Manual

Removing a misfeed

When a misfeed occurs, remove the misfed paper as explained below.
I I I I General procedure for the finisher and saddle stitch finisher
1 Gently move the finisher/saddle stitch
finisher away from the machine while
pressing the button.
2 Remove the misfed paper from the main
unit.
Open the upper cover of the finisher/
3
saddle stitch finisher.
(A)
4 Lift knob (See the step 3 figure), then
(A)
remove any misfed paper.
(B)
5 Lift knob (see the illustration in step 4)
(B)
and remove any misfed paper.
When an inserter is
installed, separate the
inserter from the
machine while pressing
on the inserter button.
After removing the
misfed paper, perform
steps 1 and 3 on page 2-
19 to reset the machine.
When an inserter is
installed, lift the tray of
the inserter.
Be careful not to tear the
misfed paper during

removal.

Be careful not to tear the
misfed paper during
removal.
FINISHER AND SADDLE STITCH FINISHER
6 Remove any misfed paper from the paper
exit area.
Close the upper cover of the finisher/
7
saddle stitch finisher.
I I I I When a saddle stitch finisher is installed
8 Open the front cover of the inserter (only
when an inserter is installed).
Open the lower cover of the saddle stitch
9
finisher.
Open the entrance cover of the saddle
10
stitch unit.
Be careful not to tear the
misfed paper during
removal.
3-11
3