Sharp AR-201 Operation Manual page 9

Zero key
Use as part of numeric keys to enter copy quantity.
Press during a continuous copy run to display the
number of copies completed in the current run.
Press during standby to display the total output count.
1st display
Press and hold down the key.
Note: A3 (11" x 17") size copies are counted as two
copies.
CLEAR ( ) key
Clears the copy quantity display or terminates a copy
run.
START ( ) key and indicator
Copying is possible when the indicator is on.
Press to start copying.
CLEAR ALL ( ) key
Clears all selected settings and returns the copier to the
initial settings.
PRESET RATIO selector keys and indicators (p.
17)
Use to sequentially select preset reduction/enlargement
copy ratios: 50%, 70%, 81%, 86%, 100%, 115%, 122%,
141%, 200% (50%, 64%, 77%, 95%, 100%, 121%,
129%, 141%, 200%).
ORIGINAL SIZE ENTER (
indicators
Use to input the original size.
AUTO PAPER SELECT (
Paper of the proper size will be automatically selected
depending on the original size and selected copy ratio
when this indicator is on.
In some countries and regions, 8-1/2" x 13" size
is indicated on the operation panel.
2nd display
12,345
sheets output
) key and
) indicator
PART NAMES AND FUNCTIONS
Inch system
TRAY SELECT ( ) key (p. 14)
Use to manually select a paper tray.
AUTO IMAGE (
Press for automatic copy ratio selection.
Paper feed location/misfeed location indica-
tors (p. 30)
The selected paper feed location is shown by a lit
indicator ( ).
The general location of misfed paper is shown by a
blinking red indicator (
DUAL PAGE COPY (
(p. 24)
Use to make individual copies of two originals placed
side by side on the original table.
ERASE ( /
Press to select the edge erase and/or the centre erase
mode. (Only available when an optional electronic
sorting kit is installed)
MARGIN SHIFT (
Shifts text or image on the copy to leave a binding
margin on the left side of the copy. (Only available when
an optional electronic sorting kit is installed)
Initial settings
The copier assumes the initial settings when it is first turned
on, when the CLEAR ALL (
proximately one minute* after the last copy is made in any
mode.
Copy ratio: 100%
Exposure: Automatic
Copy quantity: 0
All special copier modes: Off
Auto paper selection: On
Paper feed station: Previously selected paper tray
* This time (auto clear time) can be changed. See page 36,
USER PROGRAMS.
) key and indicator
).
) key and indicator
) key and indicators (p. 65)
) key and indicator (p. 67)
) key is pressed, and ap-
7