Sharp AR-201 Operation Manual page 19

REDUCTION/ENLARGEMENT/ZOOM
Manual
Place the original on the original table and close the
1
platen cover.
Use the PRESET RATIO selector (
2
zoom ( , ) keys to select the desired copy ratio.
To select a preset reduction or enlargement copy ratio, press the
or key repeatedly until the indicator for the desired copy ratio is
lit.
A. Preset reduction ratios are: 86%, 81%, 70%, and 50% (95%,
77%, 64%, and 50%).
B. Preset enlargement ratios are: 115%, 122%, 141%, and 200%
(121%, 129%, 141%, and 200%).
C. Zoom ratios: Any ratio from 50% to 200% can be set, in 1%
increments. Press the
ratio, then press the
to increase the ratio.
When a zoom ( ,
up and the zoom ratio will be displayed in the copy quantity display
for at least two seconds.
To verify a zoom setting without changing the zoom ratio, press and
hold down the copy ratio display (
the display will return to the copy quantity display.
To decrease or increase the zoom ratio rapidly, press and hold down
the or key. However the value will stop at the preset reduction
or enlargement ratios. To move beyond these ratios, release the key
and then press and hold it down again.
D. Same-size reset: Press the
copy ratio returns to 100%.
Ensure that the desired paper tray is selected.
3
If the auto paper select function has been enabled, the appropriate
copy paper size will have been automatically selected based on the
original size and the selected copy ratio. If the selected PRESET
RATIO indicator or the ZOOM indicator blinks, the selected copy
image is too large for the copy paper size.
If the auto paper select function has been disabled or if copying onto
a different size paper, use the TRAY SELECT (
paper feed station with the desired paper size.
Set the number of copies and press the START (
4
, ) keys and the
or
key to set the approximate
key to decrease the ratio or the
) key is pressed, the ZOOM indicator will light
) key. When the key is released,
or key repeatedly until the
key
) key to select the
) key.
17