M2M Easy 2 Installation Manual page 85

IXEVENT= 3
IXPART= 2
IXZONE= 3
d.) Settings of Output:
Parameter Max Char Length
Name
OUTHDEL= 4
Text Contact ID (CID) Event Codes for the
Input Nr. X, where X can be 1, 2, 3 or
4. For the input lines in case of event
can be added a CID code
(Default Value: IN1: 130, IN2: 110,
IN3: 100, IN4: 120)
Like: I1EVENT=130 (CID Code 130
for Input 1)
Text Partition value for the Input Nr. X,
where X can be 1, 2, 3 or 4.
Default value: IN1: 01, IN2..IN4: 98
Like: I1PART=01
Partition value is 01)
Text Zone value for the Input line Nr. X,
where X can be 1 or 2.
Default value: IN1: 001, IN2: 002
Like: I1ZONE=001 (Input Nr. 1 Zone
value is 001)
Parameter Description
Type
Number Switch of delay (in seconds) for the
output, which gives the output HIGH
value delay.
When configuring by SMS message it
holds to turn on the output while it
was defined then will it turn off.
In case of adding parameter '0' value
the output will be operated in normal
mode, it doesn't switches back (e.g.
setup to value 1 for the OUT1: after
the defined
switched to 0).
Default value: -
Like: OUTHDEL=0 (the output value
is 0 which means normal operation
mode without delay)
85
(Input Nr. 1
interval the output