Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for M2M MQ03-Alarm
Summary of Contents for M2M MQ03-Alarm
- Page 1 M2M Services Ltd, 1 Kukush Str, building M8, Sofia 1309, Bulgaria, Web Site: www.m2mservices.com M2M Services Ltd. MQ03-Alarm - Installer Manual V 1.2 M2M Services Ltd, 1 Kukush Str, building M8, Sofia 1309, Bulgaria, Web Site: www.m2mservices.com...
-
Page 2: Table Of Contents
Using the wireless keyfobs ......................4 Pairing a wireless keyfob ......................4 Deleting a wireless keyfob ...................... 4 Configuring the MQ03-Alarm ....................5 General settings of MQ03 Alarm .................... 5 General settings of the partition ....................5 Configuring the zones ......................6... -
Page 3: Wiring The Power Supply Module
The tamper can be connected to a zone configured as 24h tamper. SMARTEnroll – self-learning zones The MQ03-Alarm panel supports SMARTEnroll feature – preconfigured settings and self-learning zones, which in most cases eliminate the need of initial programming of the alarm panel. This simplifies the installation process in the most commonly used scenario, when only instant zones with no entry/exit time are needed. -
Page 4: Using The Wireless Keyfobs
“Configuring the zones of MQ03-Alarm”. If the default configurations are not suitable the zones can be configured by the installer, as it is described in the section “Configuring the zones of MQ03-Alarm”. Using the wireless keyfobs Pairing a wireless keyfob Up to 7 wireless keyfobs can be paired to an alarm panel. -
Page 5: Configuring The Mq03-Alarm
You can enable that feature by checking the “Auto shutdown when battery critical low” checkbox. General settings of the partition The MQ03-Alarm supports 1 Partition. You can configure different Partition settings from RControl Alarm menu, section “Partitions”: ... -
Page 6: Configuring The Zones
Configuring the zones The MQ03-Alarm supports up to 8 zones. If you need to change the default self-learning behavior, you can configure the zones from the “RControl Alarm” menu, section “Zones”. With a double click on the selected zone you can: ... - Page 7 Instant zone - If this type of zone has been violated when the panel is armed, the panel will immediately generate an alarm event. The arming of the alarm panel is not be possible if an Instant zone is violated. In this case the alarm panel sends a ContactID event E-374 (Exit Error, in Zone N), reporting the first of all the violated zones which prevent the panel from arming.
Need help?
Do you have a question about the MQ03-Alarm and is the answer not in the manual?
Questions and answers