Extollo LANSocket 1500 Product Manual page 26

2. Connect the Ethernet cable to the LANSocket 1500 adapter and the device that is to be
networked (PC, gamming console, STB etc.).
3. To add the LANSocket 1500 adapter to the existing private AVLN press and holding the
Sync button for 10 seconds and then release the button. Once the PWR LED has stopped
flashing, advance to 4.
4. On the same LANSocket 1500 adapter, press and hold the Sync button for 3 seconds and
then release the button. The PWR LED will start flashing to indicate that the LANSocket
1500 adapter is looking to join an AVLN.
Step 2:
5. Precede to one of the LANSocket 1500 adapters that are already installed in the network.
6. Press and hold the Sync button for 3 seconds on one of the existing LANSocket 1500
adapters already installed in the network and then release the button (this operation must
be done in less than 2 minutes of number 4 in Step 1). The PWR LED will flash to indicate
that the LANSocket 1500 adapter is looking to add a Powerline adapter to the private
Powerline network.
7. After approximately 20 seconds (maximum), the PWR LEDs will stop flashing to indicate
that new LANSocket 1500 adapter has been paired with the existing Powerline adapters
on the private AVLN.
8. Repeat Steps 1 and 2 to add additional LANSocket 1500 adapters to the private Powerline
network.
The information contained within this document is confidential and cannot be reproduced
without the approval of Extollo Communications.
26