Assembly Preparation - Ironman Fitness Standard Olympic Weight Bench Owner's Manual

1. Warning: It is highly recommend that you have assistance during the assembly of the
IRONMAN strength equipment.
2. Tools for assembly:
General tools needed for the assembly of the IRONMAN strength equipment.
 Metric Allen Key Set
 Metric Wrench Set or Adjustable Wrench
 Flat Screwdriver
 Phillips Screwdriver )
 Rubber Mallet
 Silicone Spray Oil
3. Insert bolts into the frame as illustrated in the drawing of each of the steps.
4. Warning: Do NOT tighten the bolts, nuts, and screws until instructed to do so.
Hand-tighten the bolts, nuts, and screw during assembly. Hand-tightening will allow for
easily aligning the parts during assembly ,
5. It is highly recommended that a professional installer assembles the IRONMAN strength
equipment. But, with the proper assistance, the right tools, and strictly following the assembly
steps, and given enough time; the assembly of the unit can be achieved without professional
help.
6. Thoroughly read each step before proceeding to assemble the items of that step.
7. To aid in assembly of the equipment, the hardware pack (bolts, nuts, washer...etc.) have been
presorted according to their corresponding steps. See Hardware Pack page.
8. When the equipment is fully assembled check all the functions for correct operation. Consult the
manual if you experience any issues, or for further help please contact our service department.
See page 2.
ASSEMBLY PREPARATION
5